The test conducted on building drainage pipes prior to installation is :
A. Smoke test
B. Straightness test
C. Water test
D. All of them
Design Of Steel Structures
Design Of Steel Structures Mcqs
What is the cheapest steel ?
A. low carbon steel
B. Special steel
C. Alloy steels
D. Stainless steels
What are the four types of steel structures ?
A. basic building frame structures
B. portal frames
C. truss structures, and grid structures
D. All of them
Lug angle is ____ ?
A. Used with channel member
B. Used with single angle member
C. Not used with double angle member
D. All the above
The statical method of plastic analysis satisfies ___ ?
A. Equilibrium and plastic moment conditions
B. Equilibrium condition only
C. Equilibrium and mechanism conditions
D. Mechanism and plastic moment conditions
If the thickness of a structural member is small as compared to its length and width, it is classified as :
A. Three dimensional
B. One dimensional
C. Two dimensional
D. None of them
The bracing provided in the plane of end posts is called:
A. Top lateral bracing
B. Bottom lateral bracing
C. Portal bracing
D. Sway bracing
The net area of round bars to resist the tension, is the area of cross section at :
A. Root of the thread
B. Mid-section
C. Both a and b
D. None of them
A column splice is used to increase ____ ?
A. Cross-sectional area of the column
B. Length of the column
C. Strength of the column
D. None of them
The risk coefficient k, depends on ____ ?
A. Basic wind speed
B. Mean probable design life of structures
C. Both a an b
D. None of them